Just installed it on my Stage and the browser mode doesn't load any Rig anymore, not even pushing manually the Bowser knob, it just stays on the last used rig.
Can I revert back to the last release one?
8.6.0 Public Beta - Browser mode doesn't work anymore (solved)
-
Kellerblues -
September 9, 2021 at 1:40 PM -
Thread is Resolved
-
-
-
Same here using browse mode even freezed the Kemper
But after a reboot of the Kemper everything worked again
-
Thx, just did and is everything is working fine again
-
Same here using browse mode even freezed the Kemper
But after a reboot of the Kemper everything worked again
Rebooted twice and was still not working, just went back to the release one and everything works again
-
Yes, this seems to be an issue specific to the Stage. Sorry!
Our engineering is looking into this....
-
Thx for confirming. Looking forward to the next Beta (and the Double Tracker)
-
A new OS build is available via the usual channels, which should fix that issue: 8.6.0.31858
The issue only affected Stage and only until these were connected to USB for the first time after a restart.
-
Just installed and everything works, thanks
-
Double Tracker
Display shows Looseness-Detune-Volume however not Stereo
???
-
Double Tracker
Display shows Looseness-Detune-Volume however not Stereo
???
Do you have it loaded into on of the Mono Stomp slots?
-
Yes, I was in Mono-Land
Thanks for help
Regards
-
Does someone else have this problem with the Double Tracker?
Periodically the volume drops but only on the right channel.
-
Installed 8.6.0.31858 on my Stage and in Performance mode loading Rigs is funny: it loads the Rig but I can't switch to another Rig.
-
Please verify the real 8.6.0 version. Is it really build 31858?
-
It is build 31858B
-
Today no problem. Yesterday I didn’t reboot the computer?