I mounted my stage to my temple board as directed in my last question to you, it fit great thank you! One last question though, did you start getting any new/extra noise when using pedals in front of the stage? All I’ve changed is mounting everything to this board, and I’ve got a background squeal if my external drive pedal is connected. Not just turned on, but connected and bypassed… Any tips?
How are you powering the external pedals? I have 7 in front of my Stage, all powered by a Cioks Sol, and is dead silent. Make also sure to have Stage and pedals plugged in the same power outlet
The most isolated of all sources, a battery. So i know its not a power issue. I’ve been using this exact setup for a couple of months the only change is the board. I don’t see how I could have created a ground loop, but I’ll try some ground lifts today and see if I can borrow a different pedal to see if it’s the pedal. When I plug directly into the Kemper it’s dead silent, so it definitely points towards the pedal, but it was was fine 2 days ago… Thanjs for the help and quick response though.
I was hoping you could help me with how you mounted your stage to your temple board. Did you put the feet back in place under the board to act like washers or did you take them out of the equation completely?
sorry for asking but I need a little help. I have Kemper stage and yesterday I ve got the player... My question is... When I have the same profile on both units and soft pad - 12 on output settings engage the sound is equal but when I disengage the pad button the stage is much louder... for cca. 6db which is a lot... Have you any idea where did I go wrong...Do you notice any difference between yours two units. Thanks
many thanks for your return in addition I fiddled around like an idiot in the OUTPUT section I no longer understand anything I do not know how to adjust my Kemper when I play on my 4x12 ENGL and when we play in bars I go directly to the mixing console with 2 XLR cables. Are the 2 settings different ?? I would like to understand all that thank you very much and
Download and read the main manual it's really a big help. All Output can be set independently to a different signal, I guess your Monitor out is set to amp only or to Direct, need to be Main Mono
