UA Ruby Pedal

FX Loop in D, deactivate AMP and CAB block

KPA FX Send >>> Ruby IN

Ruby OUT >>> KPA FX Return

Quote from vanitunes

Good day.! Does anyone know how to incorporate the new UAFX pedals - specifically, Ruby, to the Kemper? I would like to continue using the Kemper to reamp and use the effects BUT, I wish to keep the Ruby's original sound. Which cable goes in/out and WHERE? I'm breaking my head..! Grr

Profile it?

And share it...

vanitunes you can refer to this for your connections:

Use LoopStereo in one of the Stereo Slots post Amp section, and disable the amp section in the Kemper.
Sounds glorious!!

Tested in the mono and stereo loop. Did not sound better than the AC30 profile in the Kemper. Maybe this could sound better with a different workflow. Returning the Ruby.

brusky, which profile did you compare with? Just curious.

Quote

interested to know more

Quote from lk_bill

brusky, which profile did you compare with? Just curious.

This

Vox AC30 1963 Rigbusters

Tested clean and edge of breakup, no effects. Single coil and humbucker. At first my ears heard slight compression on the Kemper profile. Then i dialed in the eq to match closer both amps. It may have been due to the loop but the Ruby sounded more like in a big room though i turned the 'room' knob to 0%. overall not a big difference with clean. For sure not a game changer. For edge of breakup the Kemper profile felt to me that had more punch. Also the Ruby seem to have less headroom overall. I had to turn down the rig volume and turn up the loop volume to level. Anyhow this was just my amateur test. Maybe the UA pedals are more design to use on a pedalboard rather than in the loop of a Kemper/modeler. But for my workflow it would need to really outclass the Kemper, which i was not able to prove. Maybe one of the pro's here can do another test and show this can sound best in the effects loop.