Hey all,
It's actually been annoying me to death lately, but I haven't really had the time to try any of the potential fixes (e.g. factory reset, etc) it since I was way too busy with other stuff in life. I'll post an update if a reset or something ends up being the cure.
The Gain, Bass, Middle, Treble and Presence knobs seem to have this erratic behavior when I try to dial-in values for their respective settings. Also I should note that it happens when they're controlling whatever value they are supposed to change, e.g. Definition when trying to adjust amp parameters (Bass knob), e.g. Low Shift (Middle knob), Character (Treble knob), Cab Volume (Presence knob) etc...
They always jump up and down from like -0.3 to 3.5 instantly, or even jump the opposite way sometimes. The only way to use them properly is apparently to turn them VERY, and by that I mean VEEEERY slowly.
Weirdly enough, I don't seem to have this problem with the Volume, Master Volume, Noise Gate and Mod/Delay/Effects knobs at all.
Anyone had this problem before? Is it related to the physical knobs (well, encoders in this case) themselves or something at the software side of things? Will I have to send my Kemper in for repair or is it something fixable easily?
Thanks in advance.