Sorry!
Is my English that bad?The problem isn’t adjusting volume on the different outputs.
It’s balancing the levels between presets that is the problem.I’m sorry my English just isn’t good enough to explain the problem in another way than I already have.
The Cab Volume control that used to be a part of the cabinet block solved the problem.
In former Versions there were (beneath som other) a volume setting in the ampsection and in the cab section.
In one of the last versions one setting was canceled because they obviuosly did the same.
With the update the new amp volume setting is corrected automatically during update to the former sum of that values.
So the corrected volume should be the same as it was with the former 2 setted values.
So in my opinion there should no need for any further actions due this aspekt. It should be a same result as it was before update.
The only thing is that I am not quite sure if this is true, because I did not try it. I just think that I have read about.
If you find a difference than forget my lines.
General it is the job for all of us to make a volume balance for all rigs.
This can be done in one or more stomps (if senseful), with the Rigvolume and/or with an output preset related to a Rig.