Hi, im just trying to run my stage in stereo, my setup was this:
running 2 channels on pa panned each on L and R. kemper out on the main outs with mono cables
do you guys have another ways to run in stereo?
Hi, im just trying to run my stage in stereo, my setup was this:
running 2 channels on pa panned each on L and R. kemper out on the main outs with mono cables
do you guys have another ways to run in stereo?
hi, jprmusicman.
Make sure your Output settings page 1/1
MAIN OUTPUT is set to Master Stereo.
That's about it or you can run dual mono.
Hi, im just trying to run my stage in stereo, my setup was this:
running 2 channels on pa panned each on L and R. kemper out on the main outs with mono cables
do you guys have another ways to run in stereo?
no, what you’ve done is correct. (Providing main outs on Kemper were set to master stereo in the output section).
There is no “single cable stereo output” on the Kemper.. they’re analog outputs.
In “master stereo” mode, the main out XLR’s are left and right and you then pan those two channels at the PA.
Just to complement .... the digital S/PDIF OUT is "single cable stereo".
and Burkhard gonna scold you for using all CAPS.
Just to complement .... the digital S/PDIF OUT is "single cable stereo".
yes but the OP is asking about connecting to PA.
not typical to use spdif for that purpose ?
Sorry if hijacking: Can you run main outs to a stereo power amp to two Kemper cabs? I’m finding I have to put my Matrix power amp in bridged mode thus being mono signal split to two speakers. Have tried monitor/direct out as well but only get one side. I have adjusted the main/stereo and the monitor/direct link. I’m confused. 🤷🏻♂️
UPDATE: I figured it out. Ugh, need turn up both channels on the amp 😩🤦🏻♂️
and Burkhard gonna scold you for using all CAPS.
nope, that'd be me 😁