I guess it would be great for a new update that we could have dual amp mode, meaning left and right output can be setup with a different amp profile.
Dual amp section
-
-
Sorry, can’t do dual amps
-
This is not possibles any form with current hardware.
-
This is not possibles any form with current hardware.
Software can do that?! Left channel would go to delay and reverb to the left output and right channel goes directly to the right output after the amp section. I don’t see why this could not be possible
-
Kemper have said clearly that it isn’t possible because the hardware can only process one profile at a time.
-
Maybe some flexible routing could be achieved in the future where you could send 2 dist stomps into the cab only and route that to a different output.
-
You can try :
X slot - Delay widener
Main out stereo / used right output
Monitor stereo / used send output / Kone imprint
And You have got stereo with different cab on the sides.
-
That's not dual-amping. What you're asking is really just signal routing.
Dual amping is usually taken to mean two different profiles loaded and mixed together on-demand. -
Dual Kempers
-
You can try :
X slot - Delay widener
Main out stereo / used right output
Monitor stereo / used send output / Kone imprint
And You have got stereo with different cab on the sides.
that is genius ?
as the speaker is by far the largest contributor to the overall sound, a single amp with two different speaker routes would be pretty close to dual amping. The only problem is that the Monitor Output signal would only really be suitable for on stage as the FOH PA wouldn’t be loaded with Kemper Kones so imprints wouldn’t work as intended. They may still sound good to some people but they wouldn’t sound like the actual speaker the imprint is cloning. -
The only problem is that the Monitor Output signal would only really be suitable for on stage as the FOH PA wouldn’t be loaded with Kemper Kones so imprints.
Why not.
Imprints sounds goot even with FOR PA.
You have two option. Activated Kone without imprints ( dded external LPF around 6Khz) and second with imprints.
And If you have activated stereo monitor, you can use monitor out for Kone Cabinet. ?
-
Why not.
Imprints sounds goot even with FOR PA.
You have two option. Activated Kone without imprints ( dded external LPF around 6Khz) and second with imprints.
And If you have activated stereo monitor, you can use monitor out for Kone Cabinet. ?
Because the Kpne isn’t a flat response speaker. The Kone software in the KPA applies some DSP to compensate for this. This enables the imprints to sound as designed. When using with a speaker other than the Kone the DSP adjustment will give a different result. One which is not tailored to the imprints. Therefore, the imprints will not sound like the speakers they are modelled on. As I pointed out in my post, some pople actually like these differences which is fine but that is personal taste and is different from saying imprints sound like the modelled speakers when using a PA.
-
You can create profiles of dual amp (or more) set ups already but they will be mono
-
You can run dual amps with Kemper using a DAW by sending Kemper mono to left channel and routing a DI signal to the right channel and using a virtual amp plugin (like Guitar Rig 5) with the DI channel. Only good for studio situations but friggin' fun!