Hi,
I would need to activate and deactivate the whole stack section of my Kemper via MIDI. But what I found on the subject is this:
NRPN:
Amplifier (Address Page 10)
2 On/Off
4 Gain
6 Definition
7 Clarity
8 Power Sagging
9 Pick
10 Compressor
11 Tube Shape
12 Tube Bias
15 Direct Mix
Equalizer (Address Page 11)
2 On/Off
4 Bass
5 Middle
6 Treble
7 Presence
Cabinet (Address Page 12)
2 On/Off
3 Volume
4 High Shift
5 Low Shift
6 Character
The problem is that I'm not used to NRPN MIDI messages and how to set them in a MIDI controller. So if you guys are more educated on the subject than me please a little help would very well appreciated!