So, I'm sure this topic might have been covered already in some form or fashion, forgive me if I'm kicking a dead horse by asking it again.
I was considering getting one of these but, here's my question regarding the Kemper Profiler DI box...
Lets say we have an all tube guitar amplifier head.
If the speaker output of the guitar amp is going to the input of the Kemper Profiler DI box, isn't the signal still being colored by the power section of said amplifier? I had read somewhere that the kemper can differentiate between the preamp section of the head and the power section as it profiles from the DI box, but call me skeptical.
Would it not make more since to profile the preamp section of the head without including the power section? I ask this because lets say you run that Direct profile we just made of said guitar amp into a tube or solid state power amp and then into a cab...the signal would be getting colored twice at that point by the original amp the profile was made from AND whatever power section that's being sent into.
Would profiling the head via the Effects send or Slave Out (like on mesa heads) going straight into the kemper's return and attaching the head to a speaker cab or load box not be more effective than depending on the DI box if you're just trying to capture the preamp section of the head? Has anyone tried this?