Hello fellow profilers,
I was wondering if anyone had any advice regarding setting gain structure when recording with the Kemper.
I use SPDIF from the Kemper to an audio interface to Logic Pro X. As far as I'm aware, while recording, you want your level to be around -18 DBFS, which you can then turn up during mixing.
I have a couple of questions:
1. When the Kemper is connected to my audio interface using the SPDIF output, the Master Volume on the Kemper does not impact the signal going into the audio interface. Is that meant to be the case? I can adjust the level using the volume knob for the individual profile but the master volume knob has no effect.
2. To set the appropriate level for recording, should I just turn down the level on my audio interface or should I also turn down the volume of the individual profile on my Kemper?
Thanks,
Michael