So I just got the new Trio+ and am hearing a pretty fair amount of tone suck when I place it before the Kemper. Actually, no matter where I place it, I'm dropping a small amount of gain and a lot of top end in the guitar signal at the Trio+ Amp Out. I've run through various cables, even short little 6" insulated patch cables, and the same thing. The Mixer Out sounds great, but the Amp Out is just blah.
Has anyone else has had a chance to get theirs going and tell if they are hearing the same thing?
I'm getting around the problem atm by plugging directly into the Kemper and then feeding the Trio+ input from the Kemper Direct Out. I'm using the Trio+ Mixer Out for Bass/Drums, and a dummy cable in the Trio+ Amp Out because I don't need it -- you have to have something plugged in so the guitar signal isn't sent to the Trio+ Mixer Out. Of course, you can't use the Looper in this scenario, which is obviously problematic.