Best ways to attached the Remote to a pedalboard?

Maybe remove the 4 rubber feet and use the srewholes to mount the Remote to the pedalboard? You have to drill 4 small holes.

Why not Velcro or Dual Lock?

These work well and are easily removed without leaving any trace of ever having been there.

The magic word for me is "perforated tape" / "hanger strap".

Cut the perforated tape 3 to 5 cm long strips and screw under the feet (feet off, perforated tape underneath, screw feet back on) then screw the other side of the perforated tape to the board with self-tapping sheet metal screws.

Of course you can also use something like "Harley Benton Mounties" for expensive money

.

You could use some extra large plastic tie straps. I use them in different sizes on everything.

https://www.amazon.com/Hmrope-Premium…81782959&sr=8-6

Different options. My 2 cents: 4 layers of dual lock (without removing the feet - I hate it to do this) at the 4 corners and one in the middle of the unit. That's how the Stage is on its place on my pedalboard.

Quote from BigFishCombo

So are you putting the dual lock over the feet, or adjacent to them?

If over the feet, doesn't that raise the Remote middle higher than the dual lock can reach?

Or if adjacent to the feet, does the height of the feet compromise the dual lock connecting?

I put the dual lock next to the feet, not on them, so that the feet barely touch the board. So the unit almost stands on its feet but also on the dual lock. Does this make sense? Maybe a picture says more than a thousands words...

Quote from Pentafox

Maybe remove the 4 rubber feet and use the srewholes to mount the Remote to the pedalboard? You have to drill 4 small holes.

This is exactly what I did. It works like a charm. In fact I've used this method for a number of other boards that I've made for other people too. The trick is to keep the rubber feet but fasten them from the bottom of the board.