Please help! This has never happened in the years of using my Kemper. It also won't reboot holding rig or system and won't rebout from USB holding <>.
HELP: won't start up - keeps looping 'updating analog firmware'
-
BartD -
January 4, 2023 at 5:54 PM -
Thread is marked as Resolved.
-
-
I suggest you contact Kemper Support:
-
They just said; send it in for repair. I'm reading several posts where people experienced the same thing so I'm hoping there is a more convenient solution available.
-
If this issue is permanent, there is either a loose internal cable connection or a broken board. Sorry, for the bad news.
-
Hello,
I have the same issue a few months back...Try to boot with USB with some older firmware version ....that helps me. Good luck.🤞