Ashamed to say I just noticed this. I don't use reverb that much and I always have RM up and running for tweaking to look at. When I glanced over to the profiler after putting on a Reverb effect I went Huh?
[ANSWERED] No LED under REV on profiler. Why?
-
BayouTexan -
August 26, 2022 at 10:23 PM -
Thread is marked as Resolved.
-
-
Which slot has the reverb effect in it?
-
Which slot has the reverb effect in it?
The last slot on the profiler (number 4 of Effects) has no LED. The DLY before REV has 2 LEDs - which I also don't know why?
-
If you put the Reverb in the Reverb slot, does the LED light up?
-
The REV module has no LED at Head and Rack models. These color LEDs have the purpose to indicate the effect type. When Head and Rack models were introduced, the REV module was the exclusive place for reverb effects. So its color LED would have been constantly green. It would have been kind of meaningless. The on/off state is indicated by the button. The DLY module was also exclusive at that time and its two LEDs were constantly green, but could indicate the delay time.
Today thes modules are flexible and could hold all effect types. However, these are still the preferred choice for delay and reveb effects, as spill-over, the parameter DLY+REV Routing, and the output soucre "DLY/REV Wet" only work here. So I would expect that most of the time if not always the REV module is still used for reverb effects.
-
Thanks!
I have the rackmount version.