SPDIF Output - new option 'Git / Amplifier'

Todd78 · September 14, 2019 at 4:21 PM

Dear Kemper-Team,

it would be extremly useful to have an option for SPDIF Output -> 'Git / Amplifier', in the way that the left channel is the DI-signal (like in 'Git / Stack') and the right channel is the signal pre Cabinet, just the Amplifier - yes I know this terrible distorted sound in high gain rigs

The use case is in recording for later use/change of Impulse Responses. Works this way:

- record DI signal (left SPDIF) for later reamping

- record Amp (pre-Cab) signal (right SPDIF), especially with merged profiles for use with IR loaders

- monitoring via Main Out - since no one wants to listen without cab when recording

I think it's no big thing, just a routing and would help so much!

Thanks,

Torsten

skoczy · September 14, 2019 at 7:19 PM

Makes sense to me. Liked.

Monkey_Man · September 14, 2019 at 9:33 PM

Makes sense to me too, Todd.

If someone disables the Cab block in order to get the right-channel cabless-amp sound you speak of for tracking via S/PDIF, his main-out monitoring would lose the cab as well.

deadman42 · September 14, 2019 at 10:39 PM

+1

pippopluto · September 20, 2019 at 1:59 AM

Agreed

Todd78 · May 26, 2020 at 9:03 PM

Maybe it could be implemented via control flag like this for "Monitor Cab Off" ?? There is already room on the same screen! Please do it - cannot be too dificult to get a "SPDIF Cab OFF"

Please, I would pay extra for that feature (or of course also for the other way I mentioned in the thread opener post)