I'm a new Kemper user - through trial and error I've managed to figure out enough that I feel confident going to play a gig this weekend with it.
One thing that is kinda frustrating me is how to select a stomp/effects button and simply tell what effect you already had selected. For example, lets say in the X MOD effect I had the DLY - Dual Tape selected. If I press and hold the button at some point to get to where I can edit that effect the screen just shows "Dual Delay" for the type - it doesn't actually show the specific preset. Most of the time - especially after a reboot - if you grab the browse knob to edit it, I would THINK that it would default right to the preset you've selected...in my case DLY Dual Tape. However, it doesn't - it defaults back to the very first preset in the entire scroll list...right at the start.
I added a few pics to illustrate. The one showing "Dual Delay" is what shows AFTER I've done all the setup and saved the rig. The "Dual Tape" is the actual delay preset I used. Ideally, I'd like to be able to engage the browse button and have it default right to this preset showing me what I have selected and am using in this effect slot but again, it could end up anywhere in the effects depending on what I had selected last or again, if it's a reboot it'll start at the beginning of the entire list of effects.
This makes it terribly frustrating to figure out what effect you have selected there if you want to use it somewhere else as an example. I'm just trying to figure out an easy way to select a stomp or effects button and see exactly what preset was selected vs the general 'type' and then having to scroll around trying to re-figure out what I put in there. Hope that makes sense...