Ok, to begin with.... Kemper is AMAZING.
After recording so long with through XLR Outs, I've bought an interface (Scarlett 6i6). mind you after returning one previously (the SPDIF was faulty).
Receiving a new one. this one locks fine on Kemper unlike previous attempt. ( and YES I have set Kemper as master clock. locked at 44.1K etc)
HOWEVER- this time it pops and crackles when I monitor. I have tried three different variants of 75ohm DIGI COAX RCA leads. all with same result.
Here's the catch- Iv'e recorded as a test- GIT Studio via XLR and I'm reamping OUT from interface SPDIF back into kemper and recording analogue once again to see if the SPDIF crackles FROM the interface,
no crackle, pure nice signal.
Now testing the interface, I've just ran a loop going from spdif out to spdif in on the interface and recorded audio (spdif out to in) and to my surprise- crystal clear audio.
Is this a fair chance that my SPDIF OUT is in need of a service within my kemper?
Can anyone share a recent experience with any SPDIF Issues?
after multiple google searches...
P.S again- id like to point out. yes Kemper/Hardware/Software is locked and set to SPDIF as the Master. it's all running 44.1K and I'm using 75OHM Digi Coax cable.