Hi,
I have the same problem. Can someone please sent me the new FW so I can try if it fixes my problem to?
Thanks,
Roland
Hi,
I have the same problem. Can someone please sent me the new FW so I can try if it fixes my problem to?
Thanks,
Roland
New firmware available for download at kemper support page
Thanx!
Solved after reboot!
Display MoreHi everybody,
it's me again having some trouble. Probabely because of doing something wrong.
It's about the monitor volume. I seem not to get any volume out of the unbalanced monitor out. I didn't realise before, because I bought a monitor box only with XLR in and thought I just don't have the right cable to connect the KPA and this box. And when I connected this box with the XLR main out, it worked.
Now I tried another monitor box. This one has an unbalanced in. But when I connect it to the KPA, there's no sound either. If I connect it with the unbalanced main out, it works.
I tried to change something by changing the monitor volume in the Output section, but unfortunately this changed nothing. Can anybody tell me, what's the mistake I'm making?
Thanks in advance for your help.
Please try a reset of the System settings by pressing and holding the SYSTEM button, while switching your KPA on.
My montior and direct out was not working when I got the Kemper.
I did the system reset with Firware upgrade and now the monitor is working fine but the direct out still is not.
Is there some setting I'm missing and some silly mistake I'm making?
I always like to have the DI signal from the guitar when recording so this bothering me, please help.
My montior and direct out was not working when I got the Kemper.
I did the system reset with Firware upgrade and now the monitor is working fine but the direct out still is not.
Is there some setting I'm missing and some silly mistake I'm making?
I always like to have the DI signal from the guitar when recording so this bothering me, please help.
You have to put a mono loop in the first FX block in order to activate the send.
You have to put a mono loop in the first FX block in order to activate the send.
Thanks very much mate, I figured it would be user error!
I did read the manual but couldn't find this written, will try it later. Thanks again.
Hi
I had the same problem.
I got this mail from support:
"Hi Mikael,
Please try to initialise your KPA, you can do
that by press and hold the System Button during startup,
in the
display you will see : initialising global settings"
And now the monitor out works!
Mikael in Sweden
QuoteYou have to put a mono loop in the first FX block in order to activate the send.
Just for the record - no you don't - pressing system during startup fixes this anomaly.
hth