I explained this before in my older post ( Axe FX II + Kemper together (Kemper in the Axe FX II FXLOOP), the ULTIMATE TONE RIG!!!!!! ), but I've been asked to do it in a specific post so people can reach and look for it easily in the forum.Here it goes:
OK, after a lot of hard tweaking and testing, I finally solved it!!!! There was a problem with the volumes/ signal outputs / inputs of each unit, producing lack of dynamics/clipping/difference in sound.But I finally got it!!!!.Now the Kemper sounds and feel EXACTLY the same as it always have when connected alone as a single unit.....but now hooked inside the Axe Fx II FXLOOP.
And....here are the ultimate settings for hooking the Kemper inside the Axe FX II FXLOOP and having the Kemper signal just as it goes out of the Kemper, no coloration, no lose of dynamics, no clipping, EXACTLY the same signal you'd get from the Kemper without going thru the Axe, so you can have the Kemper as a FXLOOP in the Axe and do whatever you want with it, enjoy both units tones and even mis them.
I call this "SteelEdge's Tone Collusion" !!!!! XDDD
1 - Guitar into the Axe FX II front INSTRUMENT INPUT
2 - Axe FX II Output 2 (L unbalanced) into the the Kemper Alternative Input ---> (That takes the MONO signal of the guitar to the Kemper for processing)
3 - Kemper Main Outputs (L and R unbalanced) into the Axe2 FX Return (Input 2)----> Kemper signal procesed back to the Axe FX II in STEREO, so you can use some of the Stereo posibilities of the Kemper.
4 - Axe FX II Output 1 (L and R Balanced or TRS Unbalanced, your choice) into the M-Audio Card or the Poweramp Stereo Inputs.
Kemper Settings:
INPUT--> Alternative Input.
OUTPUT MAIN Volume : -17
SPDIF Volume: -6 (this matches the spdif volume to the output volume of the Axe, so you can compare both signals are exactly the same)
Axe Settings:
- OUTPUT 1 Knob: 9 o'clock (this matches the Axe preset average volume output to the Kemper profiles average volume output, so no significant volume changes when going from an Axe FX preset to the FXLOOP with the Kemper profile)
- OUTPUT 2 : Maximum, 5 o'clock (this makes the guitar signal coming from the Axe match the guitar signal that you'd obtain connecting the same guitar to the Kemper Input)
I/O Settings Axe FX II in the Audio Menu:
INPUT 1 : Indiferent
INPUT 2 : 2,4%
Main Input Source- Analog (In 1)
Input 1 Left Select- FRONT
Input 1 Mode- LEFT
Input 2 Mode- STEREO
Output 1 Mode- STEREO
Output 2 Mode- L+R SUM
And...the secret ingredient: You have to set the Level in the Axe FX LOOP FX block to 20.Save that as a block preset (I name it Kemper) and you just recall that block everytime you want to put the Kemper as the amp in the Axe layout.