Hi there
I tried to use the morphing, let's say same rig two gain levels. In performance mode, I choose one rig, press the rig button, change the gain then press the rig button again. Then I can switch to two different settings.
That works for some rigs and doesn't for others, don't know why ?? 
Any clue ?
Should work for all rigs. Have you saved any changes to the rig?
Should work for all rigs. Have you saved any changes to the rig?
Not sure I catch what you mean ? Both rigs that work fine and those who don't, have been modified several times and saved for month.
I noticed the faulty ones have the morph button completely unlit, then brightly lighted after pressing the rig button, while the others have a slightly lighted morph button at the beginning.
Not completely shure, what you mean by Rig button and Morph button in your description.
To enter Morph values for any continuous parameter the Rig needs to be in Morph state. That can be achieved in multiple ways
- Morph Pedal in complet toe position,
- MIDI CC#11 value 127 simulating a Morph Pedal in toe position,
- adjusting Morph Pedal in Rig Manager to toe position,
- pressing the foot buttons (Rig Buttons) in the lower row of a Stage or Remote associated with the Rig currently loaded for a second time,
- pressing the QUICK button of a HEad or Rack model while this is set up as Morph Button,
- sending MIDI CC#80 value 1 simulating a Morph Button,
- pressing the button associated with the toe position in Rig Manager.
If you trigger or simulate a button, this triggers a travel between Base Sound and Morph Sound, that by default takes two seconds defined by Rise Time and Fall Time in Rig Settings. You can only enter Morph values after this travel is completed. A bar gets displayed which reflects the current position of this travel.
Within these conditions Morphing can be set with any continuous paraneter of any Rig except a few cabinet parameters, since Morphing these would cause artefacts.
You can see on the left, the 3 buttons are the same (faulty rig), on the right, the morph button is slightly lighted. It's more obvious by looking directly at the stage.
Here is the thing : the morph page of the rig menu shows some differences (faulty first, healthy second).
Clear module and clear all doesn't show up at the top, and no morphed parameters.
What parameter is set to morph in the faulty rig?
What parameter is set to morph in the faulty rig?
None.
I was focused on gain control. I checked many rigs in performance mode, and try to morph other parameters (boost, delay, ...) The issue seems to be related to gain control only for some rigs.
It sounds like you are trying to Morph the Amp Gain control. Since liquid profiles were launched you need to morph the Generic Gain as this range can be greater than the Amp Gain
It sounds like you are trying to Morph the Amp Gain control. Since liquid profiles were launched you need to morph the Generic Gain as this range can be greater than the Amp Gain
I'm gonna try this. I'm not quite sure I understand everything about liquid profiling, especially the different types of gain, but improving thanks to you guys.
That works fine, 
