Hi! Im using 1+2 out source Di/ master mono and the signal in my DAW input is too high. How can lower it down?
Thanks for response and have a good day!
Hi! Im using 1+2 out source Di/ master mono and the signal in my DAW input is too high. How can lower it down?
Thanks for response and have a good day!
Master volume?
Master volume?
I've tried, it doesn't effect signal
there is no master volume link in usb reamping output
Then I'll wait some of the experts to jump in. I still use my 8 Channel interface....
UzlovStas Which level is too high? DI, Master Mono or both? Which levels do you read?
UzlovStas Which level is too high? DI, Master Mono or both? Which levels do you read?
Master mono is -1 or even clipping, DI -3 db
For the DI turn down CLean Sense in the Input Section. For Master Mono check the Rig Level. Is it set to a higher level?
For the DI turn down CLean Sense in the Input Section. For Master Mono check the Rig Level. Is it set to a higher level?
Rig and Amp levels are set to 0db
I've get the point how to solve my problem, but it would be great to have volume knobs on USB output for not tweeking rig volume all the time
UzlovStas Are there any post stack effects active with raised volumes?
UzlovStas Are there any post stack effects active with raised volumes?
No, just Amp and Cab
I've tried different profiles and result was the same