Direct Monitoring option will not save ON/OFF state in OS 9.0

BayouTexan · May 23, 2023 at 8:24 PM

I like to monitor thru my DAW, and I uncheck the Direct Monitor option on Page 7 of 10 in Output menu. However, after every restart, that option goes back to being checked and I have to uncheck it again.

It this behavior intended?

Do we need to make a request that it remains in it's last state?

timo · May 23, 2023 at 9:13 PM

9.0.2 ftw

Ruefus · May 23, 2023 at 9:37 PM

Quote from timo

9.0.2 ftw

BayouTexan · May 23, 2023 at 11:27 PM

Quote from timo

9.0.2 ftw

I just installed that one after setting the Direct Monitor to OFF. After the install, it put it on again.

Hopefully, the next restart will be FTW!

Burkhard · May 24, 2023 at 4:58 PM

Yes, each restart activates Direct Monitoring intentionally. Otherwise this could be a big trap since DIrect Monitoring in off-state interrupts your guitar signal. Imagine you get to a gig and don't hear your guitar.

BayouTexan · May 24, 2023 at 8:17 PM

Quote from Burkhard

Yes, each restart activates Direct Monitoring intentionally. Otherwise this could be a big trap since DIrect Monitoring in off-state interrupts your guitar signal. Imagine you get to a gig and don't hear your guitar.

I would think most would be in Performance mode for gigs. So, can the ON/OFF soft button be programed to the Direct Monitor in Browser mode?

Burkhard · May 25, 2023 at 9:47 AM

We are not planning to add more complexity, that could confuse people. We reset to Amp Recording state and Direct Monitoring off during each restart.