Hello,
I am pretty new to Kemper. Searched and could not find a technical answer to my question.
I connected XLR outputs to Mixer and at the same time Chinch Main Outputs to Power Amp.
(Reason for that is, that everything is hardly accessible and I did not want to plug and unplug the evrytime I dicide to use for just playing and then again when recording)
Is there a problem using both (all 4) main outputs at the same time?
I was wandering if there might be an overload to the Kemper, or the both the signals get to weak...
I tried to use some of the factory presets and it seems some of those can't hardly pass their own Noise Gate settings... And I have to crank up their volume to even hear them.
Could a behavior like this have something to do with my Output Setup?
Bets Regards and thank you for your help,
Jos