We have a run that needs to be 50ft from the front of the stage where the remote is to where it plugs into the Kemper backstage. We have a 50ft Cat5e and I was wondering should the POE adapter be on the Kemper side or the remote side and use just a small 3ft Cat 5e between the POE and the Remote. Would it be better to use 2x 25ft Cat 5e and put the POE in the middle of the two?
Thanks
Question - Using Ling Cat 5e with POE Adapters
-
JConstantineLV -
September 25, 2022 at 6:51 AM -
Thread is marked as Resolved.
-
-
This will enable you to bridge distances of more than 100m (300ft). The PoE injector can be located close to the PROFILER e.g. in the same rack and connected via a short ethernet cable.
manual: p. 298
-
What POE adapter is best for the profiler?
-
Hi - there are some specific brands/ models in this thread:
ThreadKemper Remote Long Cable
Does anyone have any recommendations for Kemper Remote Cables? Im looking for something at least 50ft, also do I need to make any mods to the remote itself if I plan on using a cable that is at least 50ft long? Any of you have had any situations like it? Thanks!joseafhJanuary 21, 2023 at 8:39 PM -
- Official Post
A list of tested PoE devices is included in that chapter of the Main Manual. It's all in the manual.