Hi,
I have been experiencing weird display issues lately.
After some time the unit is on, the display gets progressively blurred to the point that nothing can be properly read. After a couple of minutes, it gets completely blank and then readable again but it is basically split into two halves: the left-hand side shows the name of the rig and some parameters while the right-hand side shows the exact same info but mirrored. Very weird. I tried a factory reset but to no avail.
I have installed the latest firmware update too and yet, nothing's changed.
Is anybody experiencing the same issue?
Profiler stage display gone crazy!
-
Lux MacLeod -
October 19, 2021 at 3:20 PM -
Thread is marked as Resolved.
-
-
no, i´ve never seen the mirrored display, very strange.
i suggest contacting support:
-
I had (other) screen problems --> It's not normal --> Contact Support to fix it ! (you'll probably have to send your device back)
-
I had a similar issue on a laptop screen. Had to replace the screen.
-
Ok i was about to buy one of these units......
This is rare case or ?...
-
First units have met problems. It's rare now.
I have no problem since one year.
PS ; the support is very helpfull, present and they really solve the problem when you have one !
-
I’ve had mine since they came out and have had no problem
-
Ok i was about to buy one of these units......
This is rare case or ?...
I've been here a year and it's the first time anyone mentioned this. Thousands of others seem to be okay.
-
I've been here a year and it's the first time anyone mentioned this. Thousands of others seem to be okay.
Yes i trust German engineering i placed my order