Hello,
This might sound strange but I use the Strymon Iridium in the FX loop of the Kemper, and use the Kemper for drives Fx and so on, and I have the remote as well.
It runs perfectly but I have a problem in sending the initial program change to the Strymon to save a setting
I used the Strymon with the JOYO PXL-8 midi/looper controller, and I could setup up the Iridium, by holding the FAV button till it flashes blue, and then choose a PC change number on the JOYO, and click a switch that sends it to the iridium, it stops flashing, which means the setting as successfully saved on the iridium under that number, as it has a capacity for 300 presets, and this is the way to select a number and save it... and can be recalled once a PC message is sent again, and I saved those various PCs on the various banks of the Joyo, worked perfectly
On Performance mode, I managed to recall these already saved presets, I have like 28, so when I enter PC # 21 on the Kemper performance rig, it choses that that I already saved using the JOYO
My problem is I can not send PC messages to the iridium to save a new preset, or even tweak an existing preset on an existing number and save it
I want to make another set of presets for the Kemper, for example #30-50, using the Kemper, and later tweak them on the Kemper, I can not seem to find how to do that, I don't want to keep going back and forth to the joy and programming it and then come back to the Kemper and just recall.
I am failing to find how I can do that, the there is no button that initiates the PC command to be sent Iridium, I even tried to do it thru "assign" in browser mode, but nothing is happening. Am.i missing something?
The iridium is pretty straight forward, attached the portion of the manual which says how it works.
Appreciate any help or tips.
Sorry if I took too long to describe the issue or if it is still vague