Hi everybody!
I finally decided to get a profiler with an external power amp and it will arrive shortly.
But I'm not sure how to set it up...
My Setup will look like this:
- Kemper Profiler (unpowered)
- Palmer Macht 402 Power Amp (https://www.palmer-germany.com/en/products/gu…/5188/macht-402)
- Marshall 1960AV (https://marshall.com/marshall-amps/…60av-and-1960bv)
How Do i set it up properly without damaging everything?
Kemper Main Outs to Mixer (if possible, sometimes in small clubs we play instruments through Cabs only or even share backline.)
Kemper Monitor Out -> Palmer Input -> ?
Thanks for any help. I didn't find any useful instructions yet...
Edit: I found the manual of the Palmer Macht 402 online!
There it says: Bridged Mode - 16 Ohm - 200W
So i can put in into Bridged Mode, dial my cab on 16Ohm and then it would be
Profiler -> Palmer Input A -> Output A(bridged) -> Cabinet
and that's it, right?