I know you can do this by touching the effect button and the footswitch at the same time but lets say my board is 20 feet away, how do I assign a selected effect without having to do that?
How to assign effect to footswitch
-
Clselby -
October 15, 2020 at 8:53 PM -
Thread is marked as Resolved.
-
-
You can assign effect in page Remote Effect Buttons in Rig Setting.
Press and hold one of the four soft buttons, and press effect module button.
-
If you search the Main Manual for Effect Button and navigate to the dedicated chapter, you effectively find the answer:
Assignments without Remote
If your PROFILER Remote is not connected, or if your stage is so huge that your PROFILER is miles away from the Remote, you will not be able to reach both at the same time. In this case, enter the Remote Effect Buttons page in Rig Settings, hold one of the four soft buttons, and press one or more effect module buttons to complete the assignment.
-
Let’s say I want to assign an effect button to increase the feedback on a delay, how do I do that?
-
Let’s say I want to assign an effect button to increase the feedback on a delay, how do I do that?
Do that through Morphing.
Go to the Kemper Manual and search for Morphing. There's a whole section devoted to it.