Hi all. hope all is well. I updated my rack Kemper to 7.1.5 which is the latest version, than downloaded and installed the latest rig manager which is 3. and now when I start rig manager it says your profiler needs a newer update , 7.1.6 , this might take a few minutes to arrive. that version does not even exist. what am I doing wrong ? Paults ? Ingolf ? thanks so much in advance. cheers.
Updated to 7.1.5 now it's asking for 7.1.6 ???
-
chopshop777 -
December 7, 2019 at 5:16 PM -
Thread is marked as Resolved.
-
-
You need the latest Beta version of the Kemper OS for RM 3.0. It is 7.1.7 already at the moment.
-
You need the latest Beta version of the Kemper OS for RM 3.0. It is 7.1.7 already at the moment.
maarten1945 thanks so much. where do I get that ? in the download section ? cheers. thanks again..
-
You need the latest Beta version of the Kemper OS for RM 3.0. It is 7.1.7 already at the moment.
Ok found it. thanks so much maarten1945 cheers.
-
Ok found it. thanks so much maarten1945 cheers.
Same problem, i'm completely new to the Kemper. Can't find it inn the download section. Where did you get it?
-
Same problem, i'm completely new to the Kemper. Can't find it inn the download section. Where did you get it?
-
Select in the download section the categorie “operation system beta version”, 7.1.8 is the latest one I believe.
-
Select in the download section the categorie “operation system beta version”, 7.1.8 is the latest one I believe.
Very good point!
-
metoo. Exact the same problem.
-
For me, Rig manager updated my Rack to 7.1.5 and then told me I needed 7.1.6 but RM would never download/install it. Not sure if I had RM set up incorrectly but I ultimately put the newest OS on a flash drive and updated it that way. Worked like a charm.
-
For me, Rig manager updated my Rack to 7.1.5 and then told me I needed 7.1.6 but RM would never download/install it. Not sure if I had RM set up incorrectly but I ultimately put the newest OS on a flash drive and updated it that way. Worked like a charm.
Somebody mentioned elsewhere that RM won't install a beta software if it's also a beta version. Don't know if that's true or not, but I had to use a thumb drive to update my profiler, which I usually don't have to do.
-
yupp. metoo. needed a FAT32 formatted stick to update the toaster.
-
For me, Rig manager updated my Rack to 7.1.5 and then told me I needed 7.1.6 but RM would never download/install it. Not sure if I had RM set up incorrectly but I ultimately put the newest OS on a flash drive and updated it that way. Worked like a charm.
Same here. Rig manager is up to date as of posting this, SUGGESTS the to 7.1.6, then never does anything about it.
Upon checking for updates, the RM states everything is "up to date"
I have an extra dilemma, as my flash drive port for the kemper has broken.
All I have is the usb port.