So, I'm using a MBritt Friedman Merged profile live that just KILLS! However, there's one issue. I have a Mesa 2x12 that I like to use for my stage volume but also like to run FoH (So I can have set volume going into FoH and still adjust my stage volume as needed). I have Monitor Cab Off as instructed but herein lies my problem... The profile seems too "Bass'y" through FoH in comparison to the way it sounds through my Cab. I'd normally just toss an EQ in the chain to remove some of the low end freqs but obviously I can't do that without affecting the Mesa cab as well. I'm not at my Kemper to check but are there "Output" EQs for each output section? Would it even work that way? Basically I'm looking for a way to EQ what's going to FoH without affecting my Mesa Cab.
Any thoughts?