Great! Thanks.
I think this would be the correct switch, isn’t it?
Great! Thanks.
I think this would be the correct switch, isn’t it?
I ordered this pot and works fine but it won't fit into a crybaby mini pedal !
Raf
Great! Thanks.
I think this would be the correct switch, isn’t it?
that will work!!
Thanks!!
I did this a few years ago. See my post where i demo the pedal and if you swipe you'll see the inside of the pedal.
good work.
it’s not surprising it works so well as the Mission is basically a crybaby with all the expensive bits removed. It obviously costs so much because of the work involved taking out the crybaby circuit ?
I am using an old dunlop volume pedal, which I think is the same case as a crybaby, with a momentary switch and 10K pot from CE distribution and it works fine for the wah. I am not sure it is as good as my 1967 Vox, but it is close enough for gigging. I have been wanting to take the vox off my board because of the its value anyway.
It was really easy to switch. The pot from CE has the gear on it allready. I had to drill another hole for the switch jack.
I am using a Fender Wah that has been modified to an expression volume with 100K potentiometer. no problem.
It is more important that the potentiometer is linear, NOT log.
And please check the angle of rotation of the potentiometer, these can be different.
The angle of rotation of the potentiometer must be set from so that it gives the best linearity.
If you have a Dunlop, Vox or similar chassis you just need this Dunlop 10k Lin Poti to make your Pedal Kemper-compliant. This works perfect and lasts more than a guitarist life ?
https://www.amplifiedparts.com/products/poten…wah-10-k-linear
yes, i’m sure that’s the same Dunlop pot that’s in the Mission EP1 itself.