Tone parameter in the stack section.
If you play with humbuckers, some profiles can be difficult to lighten, even if you lower the bass and increase the high frequencies.
A tone parameter would help to do this.
Tone parameter in the stack section.
-
-
Try the definition control in the amp section.
What exactly do you mean with a "tone" control?
-
Tone parameter allows to adjust the tonal quality.
Little like on a guitar but little différent.
This allows to increase the high frequencies and lower the bass or the opposite.I had this parameter on my old Zoom G92tt.
With a humbucker pickup in bridge position, it was really easy to adjust the sound to have a high tone almost like a single coil.
With some profiles not made for humbucker, it's very difficult with the Kemper to adjust the tonal quality and have a high tone,
especially if the profile is made with a 4 x 12 cab.
Sometimes, even with the low cut and boosting the high freq up to 5 and lowering the bass, it's diffcult to obtain this result. -
Many people use the Definition parameter to do this.
-
But the definition isn't made for this.
Definition make the sound hard.
Definition make the modern, with more aggressive. -
If you can't make it sound good by using the EQ controls or the amp parameters I'd just move on and use a different profile.
Do you still have the Zoom? Can you (or someone else?) record a sample of what this control does?
I personally don't need this, but I'm interested in what it does. -
Yes i still have the Zoom.
I will make a record.