For very small gigs id like to leave my footcontroller at home.
I was thinking of a set up with 2 pedals:
- one controling gain
- one controling delay level
I cant seem to find a way to set this up.
One of those i can do with morph...but 2..
Anyone?
For very small gigs id like to leave my footcontroller at home.
I was thinking of a set up with 2 pedals:
- one controling gain
- one controling delay level
I cant seem to find a way to set this up.
One of those i can do with morph...but 2..
Anyone?
If you set up the volume pedal to be before the amp, it will control the amount of input gain.
If you set up the volume pedal to be before the amp, it will control the amount of input gain.
I do that with my volume pod...but when u want to go from clean to full od, lowering to clean sounds like the input is really to low. (Got a treble bleed)
Reducing the gain sounds better in my ears.
I do that with my volume pod...but when u want to go from clean to full od, lowering to clean sounds like the input is really to low. (Got a treble bleed)Reducing the gain sounds better in my ears.
Try as @paults suggested - setup volume pedal before the amp. It cleans the gain very well.
This particular application - setting volume pedal to control amount of signal coming to amp - just showed that only one of my guitars has very good volume pot. Rest of guitars, when I roll down vol knob, doesn't clean the gain as good as vol pedal before amp does.
You could try this and control gain or delay level via MIDI: https://thomann.de/de/midi_soluti…i_converter.htm
A standalone MIDI expression pedal would help as well but the ones I found are really expensive.
I ordered this
http://www.microdesignum.cz/EN/Products/MI…ers/MIDI-Grande
However...still i would like to control delay lvl from a pedalinput from the Kemper.
Thats not possible?...seems like such a basic feature to assign parameters to the pedal.
What about using a momentary footswitch to turn on/off the Delay slot, instead of a volume pedal?
However...still i would like to control delay lvl from a pedalinput from the Kemper.
Thats not possible?...seems like such a basic feature to assign parameters to the pedal.
Not possible without MIDI. I'd still try using a volume pedal as it can sound different than using the guitar volume pot.
There were feature requests to have more than one morph pedal before:
Enable 2 expression pedals to morph 2 different parameters withing 1 rig