If I use 2 DXR10's in stereo onstage for FRFR monitors can I then run the link Out on the 2nd DXR10 to FOH with just one channel and set to mono on the DXR10 link? If so would this be a true summing of the signal?
Yamaha DXR10 Routing Question
-
Jammer1 -
January 27, 2017 at 12:24 AM -
Thread is marked as Resolved.
-
-
If I use 2 DXR10's in stereo onstage for FRFR monitors can I then run the link Out on the 2nd DXR10 to FOH with just one channel and set to mono on the DXR10 link? If so would this be a true summing of the signal?
If you run link out on 1 of DXRs to FOH you will feed L or R mono signal there.
-
How are the two DXRs connected to the KPA?
-
How are the two DXRs connected to the KPA?
Main outs
-
If the Left Main Out is connected to one DXR, and the Right Main Out is connected to the other DXR, and the KPA is configured for Stereo Out, neither DXR contains a L+R signal, so you cannot send a L+R Mono signal from one of the DXRs.
You could send a Mono line level signal from the Monitor Output.
-
If the Left Main Out is connected to one DXR, and the Right Main Out is connected to the other DXR, and the KPA is configured for Stereo Out, neither DXR contains a L+R signal, so you cannot send a L+R Mono signal from one of the DXRs.
You could send a Mono line level signal from the Monitor Output.
Then you can unlink the Monitor Output and link the Main Output so you can control your on-stage volume by the Main Output knob.
Also, as the Monitor Output is not balanced, you may need to use a DI if you go this route.
-
Then you can unlink the Monitor Output and link the Main Output so you can control your on-stage volume by the Main Output knob.
Also, as the Monitor Output is not balanced, you may need to use a DI if you go this route.
Or use the Monitor+Direct Output as a stereo pair for the two DXR10's. Then you can use the balanced XLR Main Out (without external DI) for FOH.
-
Or use the Monitor+Direct Output as a stereo pair for the two DXR10's. Then you can use the balanced XLR Main Out (without external DI) for FOH.
Good one, yes. I always forget about the Direct Output