Hi Everyone,
Just got my remote and trying to setup morphing, one problem, base sound has no delay -- switch to morph (top led) then hit a delay. now when i switch back to base sound the delay stays on. Why ?
Thank You
Morphing Basics
-
rundoverdog -
November 28, 2016 at 2:07 AM -
Thread is Resolved
-
I am not a morph expert. But as far as I understand: you can only blend parameters, not switches. Your solution would be: swicth delay on. Set in lower LED to mix=0% and then in upper LED to your desire. This value will be morphed then.
-
@SpinnerDeluxe is correct - Morph can be used to change the value of variable parameters. It cannot be used to control switch-controlled parameters, of the on/off status of FX.
-
Thanks Guys, worked it out
