So I'm about 1 month and a half into using the Kemper. Getting ready to take out if for my first gig in a couple of weeks. I've been using it at practice to get the rigs I like dialed in for the band mix.
I've been setting up each performance by rig. I am basically following the same pattern for each of the 5 slots for each performance: 1. clean, 2. crunch, 3. crunch with mod, 4. lead, 5. lead with pure boost in the X for a 3.5b volume boost. I'm using a rocktron midi mate as my floor controller. I run it in the control mode which sends patch changes on the bottom 5 pedals and cc changes on the top 5 pedals. So, bottom 5 pedals change the performance preset and the top 5 turn on and off stomps.
I've been running into the following issues and I'm not sure how to fix them:
1. Each time I change the slot I get a message on the Profiler window that says: "Module is Empty! Please select a type or preset." I'm not sure what this means. As the message is displayed the slot changes to the programmed rig with the effects on and off and setup they way I saved it.
2. I've set the 5 slot on each performance as my lead tone with the X turned on with a 3.5 db boost. This is how I save it and its running great. Then, when I change the slot and go back to the 5, it has the follow boost and the botton for the X glows for a split second, then the volume drops to normal and the light turns off for the X button.
3. I also have a question on an option I receive when saving after I try and adjust the X button. It says : Please select what to store: "Mode/Selection" stores to a new slot "Entire Performance" stores a complete Performance.
4. The last thing I notice is that the setting for the X on the 5th preset for each profile will work as expected, patch changes and the X button is engaged, with the volume boost, when I switch to the slot using the RIG buttons. Then, when I try and repeat the same with the foot controller it does what I described in number 2 above.
I really appreciate any advice and help the community can provide. I am so close to getting this configured the way I want but I can't seem to figure this part out.