I have been trying to use the looper via the switch inputs on the kpa. I set one for loop start and one for stop. According to what I have read, it says push start and record, when you push it again, it starts playback...... So far, so good that part works. However, it is also in overdub mode. I have to click the switch twice at the end of recording to shut off overdub.then when I hit it again, it turns overdub on and again to stop overdub means to hits on switch.
Okay...... now the stop switch does not stop it. I have to hit the stop switch and then hit the start which then ends playback. I am confused because this is not what I am understanding from the manual. Help me out guys!!!
Looper Problem
-
Chalice -
August 24, 2016 at 3:20 AM -
Thread is marked as Resolved.
-
-
Are you using momentary switches (as the Kemper was designed to use), or might they be latching switches?
-
almost forgot to mention that my switches are momentary, do they need to be latching because if I assign them to stomp, etc, they work fine with the kpa.
-
Momentary switches are the correct ones.
-
I sent an email to support explaining the problem this morning and I got an unbelievably fast response from them acknowledging that they are aware of the problem using analog switches and are working on a fix. Great support response!!!!
-
As it turns out the problem is caused by the polarity of the switches that you use. Please use the polarity switch and recalibrate the switches in the system menu or select the Profiler switch option as the type on the same page and calibrate.