Fix 4 quickly we are all dying on the vine here!!
Beta 4 Firmware
-
stratabuse -
April 26, 2016 at 12:01 AM -
Thread is marked as Resolved.
-
-
hi...hasn't 4.0.2 fixed something? I see a very long log along the FW....let us know
-
Hi Everyone,
I've already opened a support ticket for this, so I'm after opinions really seeing as it is the weekend!
I had an error message a couple of weeks ago while on a FX heavy rig.
it said DSP error communication with DSP board failed.
I just pressed ok and rebooted the KPA and it worked fine. Not see it since though I haven't played much.
The second error message came today as I went to do a backup of my KPA before updating to latest firmware.
It's currently on 4.0.0.12028B. I avoided going to 4.1 as it seemed full of even more bugs.
The error message occurred as I was about to remove the USB stick after the backup process. See Photo.
Is this because I tried to backup from a beta?
i've asked support what they think I should do and I will follow their advice.
Has anyone else had either of these problems?
The only reasons I did the backup was through good habits and I had quite a few morphing rigs going on in Performance mode. wanted to keep those settings rather than start again in latest firmware if something else went wrong.
Any thoughts?
Pre-Amp -
It's currently on 4.0.0.12028B. I avoided going to 4.1 as it seemed full of even more bugs.
Please update to 4.0.2. -
Hi Timo,
Thanks for your reply.
Should I wait for support to reply or just go ahead?
Pre-Amp -
Hi Timo,
Thanks for your reply.
Should I wait for support to reply or just go ahead?
Pre-Amp
Just go ahead and update to 4.02 -
Fix 4 quickly we are all dying on the vine here!!
I really think you sould give it a try too to the 4.0.2...
-
It's currently on 4.0.0.12028B. I avoided going to 4.1 as it seemed full of even more bugs.
this is probably the worse thing you can do. as a general rule of thumb: either use the latest beta or use release versions. but don't get stuck on a beta, those are betas for a reason and i strongly disagree with you that the later beta versions are worse than the earlier ones.
gs -
Hi G-String,
Many thanks for your post. I have now updated to the most recent Beta. I have always done this in the past, but perhaps took too much notice of Forum noise with regard to the previous update. I was reading about so many negative bug related glitches that I didn't update.
I will in future revert back to updating as you have so wisely suggested.
Thanks again.
Pre-Amp -
Thanks also to Timo and Ingolf for your responses.
Pre-Amp