I want to test a few rigs at louder volumes - if anyone has KPA with DXR10 what are your monitor levels set at on the KPA and the DXR to get me in the right ballpark? I just want to get an average sort of level to work around. thx
KPA and DXR10 - what are your 'gig' level monitor settings?
-
Mic2002 -
September 18, 2015 at 2:42 PM -
Thread is marked as Resolved.
-
-
I use the KPA Monitor Out, connected to Input 2 of the DXR10.
The DXR Input Level is set to the line in between -8 and -20.
I typically have my Master Volume at 4.5 or higher, depending on the size of the stage.
-
I use the KPA Monitor Out, connected to Input 2 of the DXR10.
The DXR Input Level is set to the line in between -8 and -20.
I typically have my Master Volume at 4.5 or higher, depending on the size of the stage.
Same connection and Kemper settings here. My DXR is typically set to 9:00-10:00 o'clock. -
Thanks guys this will get me in the zone!
-
My live-settings:
-Monitor out
-DRX Input 1 (line)
-Level 0db
-Level Kemper 1-2
D-Contour Foh/Main -
I use the kpa monitor out into the 1/4" mono jack on the dxr10. Speaker volume at noon, kpa master around 5, dxr10 on a speaker stand.