3.1 OS- PROBLEM EXPRESION PEDAL

I have not played very much with things under the new firmware but at first glance it seems like my volume pedal is acting a bit off. I see the full sweep range correctly and everything looks normal in the calibration graphic but when I actually control the volume it now seems like I go from 0 volume to full volume in a very narrow sweep range range from full toe to about 20% less than full. I have my pedal located pre-effects and would expect a more linear response across the full sweep. I have two DVP-3's connected to a KPR. and believe this felt very different under 3.0.2.

Pedal calibration is now way off on my old Roland EV5 with this 3.1 Beta firmware. Worked fine with previous version, but with this release the first 75% of swell does nothing then its all in your face with the last 25%. Clearly something not right.

Some people appear to be having problems, and some do not.

What Pedal inputs and settings are you using? Problem or not?

I have 2 DVP's (inputs 4/5) and went from 3.02 to 3.1.1, skipped the one that was removed. I haven't have any problems yet with volume and wah.

Quote from paults

Some people appear to be having problems, and some do not.

What Pedal inputs and settings are you using? Problem or not?

I just have it set up as Pedal #2 controlling volume, switched back to 3.0.2 and it works fine on full sweep.

i have problems to in 3.1 it worked Before uppdate

Quote from Zapman

I have 2 DVP's (inputs 4/5) and went from 3.02 to 3.1.1, skipped the one that was removed. I haven't have any problems yet with volume and wah.

I'm using excactly the same config.

same problem here with yamaha fc7 and 3.1.1
worked fine with 3.0.2
now the calibrate button is always lit and calibrate bar changes randomly...
wah off at toe doesn't work anymore

edit
fixed in 3.1.2

My pedal is working properly again with the new 3.1.2 firmware release.