Hello fellow Kemperites,
I have a couple of profile/rigs that sound very flubby, boomy and strangely distorted on the low E string. I realize I could switch Cabinet profiles and that certainly can make a huge difference in tightening up the low frequency response. However, everything else considered, I really like how everything else is sounding on these couple of rigs.
So, I was hoping for some guidance and advice in adding some type of EQ to cut or reduce the flub and boom on the low end. What is the best way to go about this? I am not sure where this should be placed...that is, before the stack (in a Stomp slot) or after the stack. Also, I would appreciate any recommendations as to which parameters to tweak in whatever EQ effect might yield best results.
I realize this is a very general question, and I have provided limited information. However, the Reference Manual doesn't really get into details as to how to set-up such a solution. I did look into the WAH-Low Pass effect...but I am not clear as to what parameter does what, and how.
Thanks in advance.
John