Hello!
I've upgraded firmware to the latest 3 version, rebooted the Kemper and MIDI Out connection with my FCB1010 UnO4Kemper Midi In connection is gone...
Is there a way to make a loop back test on the Kemper if the midi is working properly?
I did a Factory reset on my FCB1010, also reconfigured it again based on Uno4Kemper manual instructions, tried also to change Midi channel on Kemper (from Omni) and nothing seams to work...
Same issue also when I downgraded the Kaos back to 2.7.4....
Please, any advice is welcome!
Struna