Hey folks.
I've been trying to set up my Kemper for recording a processed signal and DI signal at the same time. I am using the Kemper via SPDIF into a Focusrite Saffire Pro 24 and with Logic Pro 9.
I was hired to record the guitars for a friend's band, so I needed to set the KPA up in a way so I can hear a processed signal for monitoring while recording and for playback in my DAW, while simultaenously recording DI signals for the band to reamp later.
I got everything set up and it works, with the exception that the DI output is too hot. The input clean sense is set as low as it gets (I read in another thread that this can cause too hot of a DI output). The LED never flashes orange or even red, only green and yellow. The output LED even only lights up green at all times. I have the output set to Git / Stack and the processed signal sounds as always, while the DI is always too hot. It clips and sounds distorted. Even if I set the output to Git Studio, the DI signal is still too hot.
Am I missing something? Where else can I set up the output level of the DI when using SPDIF, so it's not too hot?