When I'm in "Performance" mode on my Kemper a "DSP Error" message showed up regarding the pedal board. It happened when I was switching between rigs in bank 1 of performance mode by pressing the pedals on my pedalboard. I turned off both Kemper and pedalboard and it worked again but after a couple of switches it does it again. Please help Kemper!
DSP Error message with Behringer FCB10101!!
-
ECW -
April 6, 2014 at 9:29 PM -
Closed -
Thread is marked as Resolved.
-
-
Just tried it there myself and I got this error:
[Blocked Image: http://oi60.tinypic.com/2mg9qh5.jpg]
-
Please open a support ticket containing this picture and including a backup of your profiler.
-
I have the same error with fcb and eureka prom.
Try to check the autoload for the perform mode in system menu.
This fixed the error for me. -
When I'm in "Performance" mode on my Kemper a "DSP Error" message showed up regarding the pedal board. It happened when I was switching between rigs in bank 1 of performance mode by pressing the pedals on my pedalboard. I turned off both Kemper and pedalboard and it worked again but after a couple of switches it does it again. Please help Kemper!
Can you please be precise in terms of which kind of Behringer FCB 1010 you are using.
a. unmodified FCB1010
b. standard Uno chip
c. Uno4Kemper
d. EurekaAre you aware, that a and b do not support bi-directional support and cannot be connected via two MIDI-cables? Only one MIDI-cable from footcontroller MIDI Out to Profiler MIDI In should be used. Otherwise you are looping back MIDI comands, that the Profiler is sending, to its own Midi input. This will cause a hang.
c and d do support bi-directional communication and should be connected via 2 MIDI-cables.
-
It has the Uno4Kemper chip. I upgraded to firmware 2.3 last night. It wasn't having the same problem today. Will try for a couple more days and post if it happens again.
-
i found that turning on the fcb after the kemper helps
-
It might be helpful to get confirmation, that this issue only happens before the Profiler has detected an Uno4Kemper board connected. As soon as the handshake has happened between Profiler and Uno4Kemper the following message gets displayed on page 6 of the System menu:
'Connected: UnO for Kemper v1.n'