Got my 1.3 UnO4Kemper chip last week and installed it. Did a system self test and calibration after installing it. I tend to keep my 1010 on and when switching my Furman on/off. I only switch on and off the KPA separately. Now, after the KPA starts up, the 1010's 1-5 pedals start blinking and I have to switch them all off. If I switch the 1010 on after the KPA has booted up, it's fine. I never had this type of behavior on 1.1. Anyone else noticed this? Or is it just mine? Perhaps I got a faulty chip?
Thanks!