I would like to reset my Kemper to stock.

mikeb · June 9, 2013 at 6:50 PM

I have been using my unit for 2 years now and it has a lot of 'junk' leftover. I would like to reset to stock. Is there a way to accomplish this?

Ingolf · June 9, 2013 at 7:15 PM

What do you mean by junk? Too many profiles?
In this case you can make a backup, rename the suffix of the backup from .kpabackup to .tar and Decompress it, then clean up all the rigs.
After that compress again, rename the .tar to .kpabackup again and restore this backup.
You should have no rigs now.
Finally you can restore the factory rigs from the systems menu.

pezi1707 · June 9, 2013 at 7:55 PM

It'salso possible to delete the whole profiles except your favorites - if you have no favorites all rigs will be deleted.
After that you can restore the factory rigs. (you can find it in the system menue)

greetz
peter

mikeb · June 10, 2013 at 5:57 PM

I really wanted a 'fresh out of the box' type reset. I did the remove everything except favorites thing but I feel like there are presets and stuff I want to get rid of and set back to stock. Maybe I am being stupid?

Ingolf · June 10, 2013 at 8:02 PM

In my procedure from above you can also clean up FX presets etc.

DamianGreda · April 27, 2015 at 6:30 PM

Attention!! You will loose all your content and settings!!!!!:

Turn off KPA
hold soft 1 button
Turn on KPA to Tuner mode holding soft 1
enter recovery with soft 1
Press soft 3 Init&Factory Content
press soft 2 for yes.

Zappledan · April 29, 2015 at 4:50 PM

Quote from DamianGreda

Attention!! You will loose all your content and settings!!!!!:

Turn off KPA
hold soft 1 button
Turn on KPA to Tuner mode holding soft 1
enter recovery with soft 1
Press soft 3 Init&Factory Content
press soft 2 for yes.

Do a backup first ...

malleteer · September 18, 2019 at 2:48 PM

i already dit a back up rig manager content and reloaded

them again