What is the network connection on the back of the kemper intended for?
Is it for some future app we yet don´t know anything about? 
What is the network connection on the back of the kemper intended for?
-
SpaceBlues -
November 1, 2012 at 9:33 AM -
Closed -
Thread is marked as Resolved.
-
I'm pretty sure it will be the connection for the Kemper foot controller.
-
Correct
-
Ok! Sounds reasonable....all we have to do is wait and see then
-
I don't think so...
According to recovery mode tests, it seems there is an ethernet chip inside.
I suspect an embedded web editor/command will be released.
I can imagine we could pilot KPA from the control room in a web browser in near future... -
I don't know if there will be more function available thru the ethernet connector, but if you see the thread about the KPA FC you see that it will have a ethernet connector for sure.
Let's hope we'll have something like what you think too
-
That's right !
I hope too... -
I'm pretty sure it will be the connection for the Kemper foot controller.
+1. Digitech does the same with the GSP1101/Control 2. It allows power and data transfer and Cat 5 cable is very easy and affordable to replace in the case a replacement is needed.
-
Line6 as well, they always did...
