Better Control for Knob Values via Typing Entry

mwrightmusic · September 2, 2024 at 6:48 PM New

*Applies to Rig Manager

In Rig Manager, you can only control values by carefully moving your mouse on a knob.

It would be great if we could double click the number and enter in a specific value.

Values are a little difficult to zero, and specific values are extremely hard to get.

Oftentimes, the knob values skip over specific numbers.

Try getting 50% mix on a delay instead of 49% or 51%.

Wheresthedug · September 2, 2024 at 7:44 PM New

This has been asked for many many times over the years but so far to no avail. At the moment you can get fine tuning mode by holding shift but I agree that just double clicking and typing a value is often the fastest, most efficient way of doing things.

mwrightmusic · September 3, 2024 at 10:52 PM New

Quote from Wheresthedug

This has been asked for many many times over the years but so far to no avail. At the moment you can get fine tuning mode by holding shift but I agree that just double clicking and typing a value is often the fastest, most efficient way of doing things.

At this point, can we have someone just decompile rig manager? lol

G String · September 4, 2024 at 8:51 AM New Official Post

As stated above, you can fine-tune a parameter by holding shift. This works fine; this way, you can reach specific values more easily. In the analog world, you wouldn't be able to reliably hit 50% (instead of 49 and 51), and I don't think that anybody ever had an issue with that.

I'll close this thread now.

G String September 4, 2024 at 8:51 AM