Player Power Supply Issue

spe_100 · April 11, 2024 at 1:16 AM

Hi all. I was using an older Dunlop DC Brick power supply, and I had my Player both daisy chained and plugged into the 9v jack on the Brick (not at the same time). No problem. Just got a Rockboard ISO Power Block V6+, which is smaller and fits under my pedal board. But it's not enough to power my Kemper, either daisy chained or plugged directly in at 9v. Also tried it at 12v (the ISO has variable inputs, up to 18v, all at 500 mA). Would it hurt my Kemper if I tried it at 18v? And would it work if I got a splitter and plugged it in to two of the ISO inputs? Thanks.

HELL-G · April 11, 2024 at 7:55 AM Official Post

spe_100 Do not try 18V, it will damage the Player.

BillyNoSocks · April 11, 2024 at 8:03 AM

i seem to recall that the Player requires 2000mA. your supply only delivers 500mA. mods, please correct me if i'm misremembering.

Guenter · April 12, 2024 at 4:34 PM

Hi, this will work https://www.thomann.de/de/cioks_crux.htm . However, you'll need an CIOKS ... in addition.

Ruefus · April 12, 2024 at 5:54 PM

500ma will not run the Player. At 9 volts, you'd need to combine all 5 of those outlets....and you'd still be below the recommended current.

DO NOT us 18volts. You'll destroy it.

Player Power Supply Issue

Similar Threads

Spare power supply for Player?

Player headphone noise??

Profiler Player wall wart noise