I have a jam coming up, 5 songs. The PA isnt that good and there is only a roland cube as backline. Can I use the input of the cube to amplify my kemper stage? It has no fx return. Or do i need to take my full speaker setup (for a jam a bit to much imo)
![](https://forum.kemper-amps.com/wbb/images/avatars/c7/4637-c729fc95812c89a8bdd316d3f0f81e28363924ea.jpg)
Jam advice needed
-
DutchGuitarDude1 -
January 31, 2024 at 7:09 PM -
Thread is marked as Resolved.
-
-
It’ll work. Not going to have a flat response, but unless your tone demands are Eric Johnson-level, I see no reason to drag more gear for a short jam.
Plug in. Tweak Definition, then B, M, T & P (if needed) to taste and go with it.
-
It’ll work. Not going to have a flat response, but unless your tone demands are Eric Johnson-level, I see no reason to drag more gear for a short jam.
Plug in. Tweak Definition, then B, M, T & P (if needed) to taste and go with it.
I was thinking using the monitors out without cab sim. Like i run my setup with regular power amp and guitar speakers.
-
It’ll work. Not going to have a flat response, but unless your tone demands are Eric Johnson-level, I see no reason to drag more gear for a short jam.
Plug in. Tweak Definition, then B, M, T & P (if needed) to taste and go with it.
Is there an option to mix the stereo to mono by the flick of a switch? Normally i play stereo.
-
You can set it in the output section. Choose Master Mono for the output you want.
-
I was thinking using the monitors out without cab sim. Like i run my setup with regular power amp and guitar speakers.
Try it both ways. Depending on the speaker it might sound good....and it might sound horrible.